1K CONCRETE EFFECT for Concrete-like finish

1. The substrate must be load-bearing, dry and free from dirt and release agents.
2. Mix CONCRETE EFFECT powder with water at a ratio of 5:2 (e.g. 1 kg powder with 400 ml water). Especially for decorative applications, we recommend adding more water, e.g. at a mixing ratio of 2:1 (1 kg powder with 500 ml water) or 3:2 (1 kg powder with 666 ml water). In this case, the material can also be conveniently applied with a brush.
3. Add approx. 2% WB Pigment, measured against the amount of powder and water, to colour the material.
4. Apply the material with a trowel, brush or by hand. Working time: approx. 30 min. Consumption: approx. 1 kg/m² per 1 mm layer thickness. Drying time: approx. 24 hrs.

For wet rooms, surfaces with direct water contact, as well as heavily used surfaces (high mechanical load, cleaning with aggressive cleaning agents, etc.), we recommend sealing the surface with EPODEX Polyurethane Resin (PU Finish) in matte.

1. To mix, pour the entire contents of PU Finish Component B into the container of PU Finish Component A and mix thoroughly.
2. Apply the material thinly and in a crosshatch pattern using a paint roller and brush. First paint laterally to the light source, then wet-on-wet in the direction of the light to avoid visible brush marks.
   Important: Especially inside the shower and in areas with permanent water contact, we recommend applying our PU Finish exclusively with a brush (e.g. 10 cm width) in a crosshatch pattern to fully close all pores. For heavily textured surfaces outside the wet area, a brush should also be used (and not a paint roller). We recommend two coats.
3. Allow the material to cure for at least 16 hours, then apply the second coat.
4. Allow the material to cure for 48 hours after the second coat. Inside the shower and in areas with permanent water contact, allow 7 days to cure before the coating comes into contact with water.