Microcement Set for Furniture

✓ Guaranteed hassle-free shopping experience. Simply select the colour and the square footage you want to cover. We automatically calculate the required amount of microcement and dye for you. 

✓ No surprises. You always get the colour you see online. We present all our colours in 4K videos and high-resolution pictures so you can see exactly what you are getting.

✓ Professional, easy-to-follow step-by-step tutorials. 

✓ Same Day Shipping

✓ Delivery across Canada

✓ Friendly 24h-Support 

1. The substrate must be stable, dry, and free of dirt, separating agents, and coarse unevenness.
2. Sand off any unevenness.
3. If required use our Putty Primer to level and prime your furniture.
4. If your furniture is already leveled and smooth, use either our 2K Bonding Primer (for-non absorbent surfaces) or DEEP PRIMER (for absorbent surfaces) to prime your furniture.

1. Mix microcement A components in medium grain size with the Liquid B component in a ratio of 100:20 by weight (i.e 7 kg Powder A-component with 1.4 kg Liquid B-component).
2. Add 2% WB pigment to colour the material (i.e. 2x 100 g WB Pigment to 7 kg Powder A-component and 1.4 kg Liquid B-component).
3. Spread the material thinly with a trowel and allow to dry.
4. Sand off any unevenness in the surface greater than 3 mm and vacuum up any sanding dust.
5. Apply a second coat in the same way within 24 hours.

Pro Tip: Up to 10% WB Pigment can be added for more intense colours. If you exceed 24 hours between the microcement layers, sand the first layer and remove the dust. This roughens the surface for better bonding and ensures the next layer won't break off. For stubborn fine particles, use a light brush of liquid B. Brush or roll on a small amount to avoid flooding the surface. 

Note: For wet rooms, surfaces with direct water contact, as well as heavily used surfaces (high mechanical load, cleaning with aggressive cleaning agents, etc.), we recommend sealing the surface with EPODEX Polyurethane Resin (PU Finish) in matte.

1. To mix, pour the entire contents of PU Finish Component B into the container of PU Finish Component A and mix thoroughly.
2. Apply the material thinly and in a crosshatch pattern using a paint roller and brush. First paint laterally to the light source, then wet-on-wet in the direction of the light to avoid visible brush marks.
   Important: Especially inside the shower and in areas with permanent water contact, we recommend applying our PU Finish exclusively with a brush (e.g. 10 cm width) in a crosshatch pattern to fully close all pores. For heavily textured surfaces outside the wet area, a brush should also be used (and not a paint roller). We recommend two coats.
3. Allow the material to cure for at least 16 hours, then apply the second coat.
4. Allow the material to cure for 48 hours after the second coat. Inside the shower and in areas with permanent water contact, allow 7 days to cure before the coating comes into contact with water.

Pro Tip: To ensure that your PU is applied everywhere, apply the quantity received in 2 coats. By applying 2 coats in a criss-cross motion, the chance of an unsealed gap is greatly reduced. 

Customer Service: If you have further questions, please contact us by phone, e-mail or use our WhatsApp support. 

Note: Please note that due to different lighting conditions and monitors, the colours may not be uniformly displayed.