EP Leveling Compound - 2K Epoxy Resin Leveling Compound for Pouring and Spreading

Dust, oil, grease and release agents must be removed in advance using suitable methods. Application should be carried out at 10-30 °C (room and substrate temperature) and a maximum relative humidity of 70 %.

1. For mixing, pour the complete contents of EP Levelling Compound component B and 10 kg of quartz sand into the container of EP Levelling Compound component A and mix slowly and thoroughly with a drill for approx. 3 minutes at 300-400 rpm. 
   Working Time: approx. 30 minutes at 20 °C.
2. Immediately after mixing, pour the mixture onto the floor, spread it evenly with a surface squeegee and then deaerate with a spiked roller to achieve an even surface and a smooth finish.
3. During curing, protect the area from moisture, dust and mechanical stress. Walkable after approx. 15 hours, fully load-bearing after approx. 7 days (temperature-dependent).
4. Apply Microcement, EP Industry, EP Design or PU Design coating Subsequent coating with other products may be applied at 20 °C no earlier than 15 hours and no later than 36 hours after application of EP Levelling Compound. 
   Important: If the subsequent coating is not applied within 36 hours, the EP Levelling Compound must, while still fresh, be broadcast with quartz sand (recommended amount: approx. 500 g/m²) for EP Industry, EP Design and PU Design systems. For microcement, the cured EP Levelling Compound must instead be sanded until it is completely matt (white haze) before the microcement can be applied. If quartz sand has been broadcast, remove any loose excess sand using a broom before applying the next coating.

Colour deviations are possible due to raw material variations. When using different batches, base components should be pre-mixed. UV radiation and weathering may cause slight colour changes. To avoid curing and mixing problems, components A and B must first be thoroughly mixed, then transferred into a second clean container and mixed again.